We typically test knives by doing the forms of things IвЂ™d usually do by having a blade. Despite the undeniable fact that IвЂ™m a fan of destruction tests as a whole, we donвЂ™t think things that are such super helpful and we certainly donвЂ™t do them whenever I do an assessment. Additionally, great deal of that time period we purchase the blades, therefore I donвЂ™t would you like to destroy them since I intend on with them.
But, the Scout is a loaner, being who owns a Dawson, i understand exactly how tough these blades are. And so I went ahead and beat the heck from it.
We have some big, downed oak limbs that I prefer for knife tests, and so I began when I typically do by skinning the dried bark off some branches and whittling them. We cut v-notches, made sticks that are feather made primitive spears, did the obligatory batoning, utilized the blade tip to drill holes when you look at the lumber, and usually worked the blade a great deal.
Regardless of some scuffing regarding the Cerakote, the blade organized fine, as you expected. The combination of DawsonвЂ™s astoundingly razor-sharp side, the high-carbon metal, therefore the temperature treat ensures that this knife cuts just like a demon and does not get dull. Also after every one of the cutting, https://datingmentor.org/escort/south-bend/ the blade wasnвЂ™t significantly duller and would nevertheless shave, therefore I chose to see just what it can do.
I acquired a typical nail that is galvanized of my toolbox and laid it throughout the top of a bit of oak. We donned my security spectacles, acquired a mallet, along with a two whacks that are sharp the back associated with the blade We drove the blade clean through the nail and in to the lumber.
As you care able to see through the photos below, thereвЂ™s a small little bit of steel that had been chipped down on one region of the side, but very nearly none on the other hand. That area of the advantage continues to be sharp, however itвЂ™s only a bit thinner due to the chip.
Therefore that it would pass right through a nail and keep going without ruining the edge if I were driving this blade down through some wood, I feel confident. perhaps perhaps Not that IвЂ™d purposefully want to do this kind of thing by having a blade, however you never understand what sort of situation youвЂ™ll end up in on the go.
The the next thing we did using the knife ended up being dig a gap. IвЂ™ve always thought that the simplest way to dig a opening with a blade is to try using the blade to cut a razor-sharp stick that one may then dig with, but I’m sure some dudes really think they must be in a position to dig having a blade. Therefore I dug an opening in my own garden, that has a layer of topsoil after which stones and clay beneath. We wound up cutting a number of the clay and getting rid of it in chunks.
The only real noticeable influence on the blade had been, once once once again, scuffing of this Cerakote finish. Cutting the clay dulled it from frightening razor- razor- sharp to regular-knife-sharp.
I attempted to utilize the blade by having a Swedish Firesteel pole, and I also might get a spark aided by the flattened pommel if We worked at it. But it is not actually an use that is ideal of blade. YouвЂ™ll get far better outcomes if you pack a piece that is little of blade or something like that comparable to make use of by having a pole. The spark i acquired ended up being anemic, and IвЂ™d hate to own to be determined by it for a fire. In the event that Cerakote were entirely scraped from the part associated with pommel, it can probably operate better. So, for many its flexibility, this isn’t a firesteel blade. Maybe perhaps Not a downside since I donвЂ™t use my knives that way, but it may be for some for me.